SUMMARY REVIEW NO. 1
11 апреля, 2014 
Oleg Maloletnikov Graph paper is provided at the end of this review for your use. Refer to the drawing, Bearing Support Bracket, page 36.
1. What scale size is used? 11. List the types of lines found on the print.
2. With reference to the above scale, what linear length on the drawing represents a dimension of 8"?
3. List any notes found on the print.
12. Convert the common fraction dimensions to
|
4. List an item classified as a specification. |
decimal fraction dimensions and apply them to the drawing next to the common fraction dimensions.
5. What are the location dimensions for the drilled holes?
|
6. List the location dimensions for the square holes. |
13. Prepare a sketch that illustrates two intersecting arcs with equal radii. Use one of the techniques previously described in the text. Show all guidelines and points for developing each arc.
|
ON THIS SIDE OF THE POINT SHOW THE ARC AS CONCAVE |
7. a. What are the dimensions for the following distances?
LOCATE A POINT AT WHICH THE ARCS ARE TO INTERSECT
|
© © © ® |
<S
(c -
(D
b. I f dimension had been included on the drawing, identify the kind of dimension it would be classified as.
ON THIS SIDE OF THE POINT SHOW THE ARC AS CONVEX
14. a. Prepare a right oblique sketch of the following three-view orthographic drawings.
b. Which of the orthographic views is incomplete?
|
c. Correct the view that is incomplete. |
8. What line in the top view is represented by surface K?
9. What corner(s) in the front view are represented by line J
10. What method of dimensioning is shown to the right of the top view?
|
16. |
|
17. What fractional size is the drilled hole? |
|
18. List the location dimensions for: |
|
a. Drilled holes |
|
b. holes |
15. a. Prepare a right isometric sketch of the
following three-view orthographic drawing.
b. Identify the orthographic views represented.
e. Complete the leader on the drawing to show how the radius of the largest circumference would be dimensioned. Use a 3" radius dimension.
f. On the drawing, add the dimension for the bored hole (11/4" dimension).
g. Add the basic size that could be applied to each of the views. Use approximate sizes.
What is dimension
c. Show the location and size dimensions that would be applied to the drilled holes. Use hypothetical dimensions for this purpose and apply them to the appropriate orthographic view.
d. How many separate pieces are required to fabricate the unit as shown?
Опубликовано в BLUEPRINT READING FOR WELDERS